The regular S meter is not connected to the sub receiver and it will only
read what the main receiver is listening to. The sub has its own bar-graph
meter on the screen.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Rick Dougherty NQ4I" <nq4i@contesting.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, April 27, 2009 10:32 AM
Subject: Re: [TenTec] BC Freq selections
> Hi Ralph....thanks for the info..it does work, but I was disappointed in
> the
> smeter not be very active...a local bc station was only s3...de Rick NQ4I
>
> On Mon, Apr 27, 2009 at 12:11 PM, Ralph Matheny
> <mathenyr@marietta.edu>wrote:
>
>> You can select BC freqs on either VFO, IF the VFO is not assigned to the
>> transmitter. This is true on the ver of firmware I have (1.372, I think)
>> but may be different on other versions.
>>
>> So--to answer the original question, assign VFO A (or B) to the SUB rx,
>> making sure that the chosen VFO is NOT assigned to transmit. Then
>> depress
>> VFO A enter, (freq display clears) enter "4455.9" (or whatever), and
>> depress VFO A enter again. You should be tuned to listen on 4455.9Khz.
>>
>> Only the sub receiver will tune very far beyond the ham bands. After the
>> overlap (allowed for MARS Freqs) the software blocks your "adventure".
>>
>> Ralph Matheny
>> K8RYU
>> 207 Gibbons Place
>> Marietta Ohio 45750
>> mathenyr@marietta.edu
>>
>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|