TenTec
[Top] [All Lists]

Re: [TenTec] Two Century 21 problems

To: <n0jmy@hayseedhamfest.com>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Two Century 21 problems
From: "Frank Holladay" <holladayfd@multipro.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 14 Jun 2009 16:04:21 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Be very sure that if you use the purple Loc-Tite that you will never need to 
remove the knob.  Once that stuff sets up, it is there forever plus three 
days!
Frank,
 K4VMO

----- Original Message ----- 
From: "Tom NØJMY" <n0jmy@hayseedhamfest.com>
To: "Mike Bryce" <prosolar@sssnet.com>
Cc: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, June 14, 2009 3:41 PM
Subject: Re: [TenTec] Two Century 21 problems


Got 'er.  Now on to the set-screws.  The missing audio was primarily due
to one of the little coil leads on the speaker being broken.  Apparently
it was weak and the loud calibrator vibrations finished her off.

And, Mike was right, that selectivity switch *was* dirty, making it
intermittent.  Got that taken care of and we're in business.

Now for the knobs.

73,
Tom

Tom NØJMY wrote:
> Well, we may have multiple problems here.  But I did get the audio
> back...for now.  I decided to check and see if there was any sidetone.
>
> With a dummy load hooked up I tapped the leads from the power set switch
> together - had power our but no sidetone.  Don't know what possessed me,
> but I decided to take a listen through the headphones.  Voila, sidetone,
> and after tickling around a little bit I had some receive audio.
>
> So I messed with the selectivity switch again and bingo, full audio!
>
> Pull the headphone plug out - silence.
>
> So, I guess I'll definitely clean that switch, then go after the
> headphone-jack/speaker circuit to see what gives.  I'd like to think
> that it was something as simple as a bad connection at the jack, or even
> if the loud signal from the calibrator just blew out the speaker. Things
> are never that simple, though.
>
> Then I can try out some of the suggestions on my set-screws.
>
> 73,
> Tom
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>