Suggested steps: 1) check all wiring harness connectors on the IF board,
the IF/AF board, next go to the lower pot board and inspect the af-rf pot
closely. Insure you do not have any broken solder joints or cracked solder
joints. At this time, if you can get at it, get some cleaner into the pot
and work it. 2) Go through the receiver alignment procedure in the manual.
3) if all else fails, call TT service for advise.
Note, as these radios begin to get some age on them, its a good idea to go
through all the connectors with some deoxit to insure good contact. This is
often a first step in working on many radios that approach this age and
older.
David
Wd9cmd
----- Original Message -----
From: <w5ot@aol.com>
To: <tentec@contesting.com>
Sent: Saturday, June 27, 2009 11:55 AM
Subject: Re: [TenTec] Omni VI plus receiver problem
Yes, the problem only occurs near the rf gain maximum.
-----Original Message-----
From: Richards <jruing@ameritech.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Sat, Jun 27, 2009 5:40 am
Subject: Re: [TenTec] Omni VI plus receiver problem
Whenever I get anything odd, I reboot the rig and do a
refresh of the software,
Didja try that?
What happens if you lower RF gain? Does it act right if
you do?
============== JR ================
w5ot@aol.com wrote:
My receiver emits a wind tunnel like rushing sound
==================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|