TenTec
[Top] [All Lists]

[TenTec] Weak Output from 706 Microphone and your recommendations.

To: tentec@contesting.com
Subject: [TenTec] Weak Output from 706 Microphone and your recommendations.
From: "Paul K." <hglent@frii.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 22 Jul 2009 10:52:39 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I have a model 706 desk mic that has lost most of the out put. It still 
has output, but I must run the Mic Gain on the Orion 1 up to 50 to 75, 
and it will drive the VOX marginally. I have replaced the element with 
one I purchased from Ten Tec.  Still the out put level is very low.  I 
just checked with Paul Clinton in the Service Department on purchasing a 
new board.  He tells me the boards are not available, but he could run 
it through the shop at $60.00 an hour.  Probably in the neighborhood of 
$120.00 for the repair. 
So, the question is, has any one had this experience with the 706, and 
if so what was the fix?  Secondly, I would like recommendations on a 
replacement mic for the Orion 1.  I seldom us SSB as I op mostly CW, but 
when I do op SSB I like a desk mic.  So what are the recommendations?

Paul K
TNX ... es ... 73S ... de ... WA0BAG
DIT  ..  ..DIT


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>