Hello Stuart-
Thank you so much for the nice advice. I have noticed electrolytics in
the AGC circuit and they are fairly old, so that will be my first try!
Thanks, Byron
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, August 04, 2009 2:21 PM
Subject: Re: [TenTec] Argonaut 509 Bias Mod
> Byron,
> I "think" the pop on strong stations on the 509 is audio derived AGC.
> As I recall, and I am going from uncertain memory, rigs with audio
> derived AGC have to use a large capacitor which charges up. The pop is
> an artifact of that design. It "may" improve if the capacitors are
> updated to fresh ones. Look for an electrolytic typically. This is a
> problem not only on the 509 but also on many simple kit QRP rigs today
> with that type of AGC. A work around might be to add an RF attenuator
> to cut down the signal level of extremely strong stations.
>
> Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|