John:
You can extract the sockets and squeeze them to make them tighter. A
little Deoxit will help, too. Mouser Electronics has the pins, sockets
and shells.
73,
Bob WB2VUF
John Hensley wrote:
Good morning to the list,
This is my first post. I have a used Ten Tec transceiver with theModel 962 power supply.
The power supply cable has 4 heavy wireswhich terminate at a 4 pin Molex connector. When
I put it on thetranceiver, it sort of "falls " on. In other words the female
pins onthe 4 pin cable connector are loose. Now it stands to reason thatthis is common
but I don't want to draw high current like this.
My question is should I extract the pins and replace them or is itnormally
sufficient for high power to use the extractor to form themback a bit ? Along
with this question, can anyone recommend a sourcefor these Molex fittings?
Thanks in advance,
John
_________________________________________________________________
With Windows Live, you can organize, edit, and share your photos.
http://www.windowslive.com/Desktop/PhotoGallery
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|