TenTec
[Top] [All Lists]

[TenTec] Omni VII: RF in TX Audio

To: Ten Tec Reflector <tentec@contesting.com>
Subject: [TenTec] Omni VII: RF in TX Audio
From: David and Dianne on Comcast <dhhdeh@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 24 Oct 2009 14:20:02 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi All,

This past week I added a 'new to me' Omni VII to the shack along with 
the #715 speech processor.  The rig has been excellent so far expect for 
one glitch that is avoiding any remedy I try.

I am using a TT 705 microphone,  When I feed it into the Omni VII via a 
TT #710 4 to 8 pin mic adapter I get stellar audio reports. But when I 
feed it through the #715 to the rig I get reports of significant RF on 
my TX audio whether or not the #715 processor is in-line/active or bypassed.

I have used the 715 on my Omni V.9 using the same mic with no problem.

I have also noticed that the Omni VII audio/mic gain seems really 'hot'  
(i.e. excess gain) requiring me to run it at no more than 10% open. Is 
this normal?

Anyone else have a similar situation and/or a possible solution? Please 
reply off list.

Thanks to all in advance.

BTW this is a really excellent receiver with a nice features set

73 de N1LQ-Dave




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>