| To: | "TenTec Discussion" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] OMNI VI+ RS-232 |
| From: | "N4YG" <n4yg@comcast.net> |
| Reply-to: | N4YG <n4yg@comcast.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 29 Oct 2009 09:11:45 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
I am getting errors in frequency reported back from the OMNI via the serial link. These are repeatable in that they always occur at the same frequencies, but are different when tuning upward from the error that occur when tuning downward. I suspect other have observed the same phenomenon. If so, has anyone found a solution? Joe |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Paragon II Question, Ed Purvis |
|---|---|
| Next by Date: | [TenTec] Corsair (Model 560) frequency display derivation, Keith Johnson |
| Previous by Thread: | [TenTec] Omni VI FS, Arthur Lewis |
| Next by Thread: | [TenTec] Corsair (Model 560) frequency display derivation, Keith Johnson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |