TenTec
[Top] [All Lists]

[TenTec] OmniVI: question about T/R control logic

To: tentec@contesting.com
Subject: [TenTec] OmniVI: question about T/R control logic
From: Allan Taylor <k7gt.cw@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Dec 2009 11:26:19 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I now have a pair of OmniVIs and would like to use them in a sort of
poor-man's SO2R. Actually I
believe what I want to do is called SO2V but will actually be with two
radios. What I would like to do
is to have both radios functional on receive, and have the alternate
radio's (radio B) T/R PIN diode switch activated when the primary
radio(radio A)  is transmitting, thus protecting the front end of the
alternate radio (radio B). Thus the question: Does the PIN diode
switch activate a) when the key is pressed/entered, b) when the signal
from the QSK loop / amp is returned, or c) at some other time. The
easiest solution would be to use radio A's QSK loop in some way to
activate radio B's T/R PIN switch. As the control logic is inside a
chip rather than in hardware, staring at the schematic does no good.

Any takers for this question??

-- 
73     Allan    K7GT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>