TenTec
[Top] [All Lists]

Re: [TenTec] more oscilloscope questions

To: Ten Tec <tentec@contesting.com>
Subject: Re: [TenTec] more oscilloscope questions
From: Paul Gates <kd3jf@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 13 Jul 2010 07:40:58 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I hope that soon you engineers can put aside the subject of Oscilloscopes and 
get on another subject.

KD3JF

Paul Gates


 
> From: wa4oss@earthlink.net
> To: tentec@contesting.com
> Date: Mon, 12 Jul 2010 15:53:18 -0400
> Subject: Re: [TenTec] more oscilloscope questions
> 
> I have attempted to avoid this continuing subject. However after reading the 
> post by Stuart Rohre, I could not resist. I think he may have hit on the area 
> of intent for the original question/post.
> 
> I have used the scopes of the fifties, sixties and current. Beginning with 
> RCA, Eico, Dumont, Heathkit and going on to Tektronix 524D, 535, 310, 922, 
> 460 series, 5000 and 7000 series and the later less expensive 2200 series and 
> TDS series. I currently own an Instek GDS 2202 digital and a LG OS5060A 
> analog.
> 
> The high end scope would be great, however it will cost more, probably can't 
> easily be repaired or be too costly for same. Also is more scope than this 
> person seemed to desire. I like Stuart have found many good buys in scopes 
> from 20 to 100mhz, and in several brands. I found the lesser expensive Tek 
> 2000 series to be quite good for applications the typical amateur should 
> require.
> 
> I hope the person that started this can find a satisfactory scope for his 
> purpose, learn and move on to more scope if deemed necessary.
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
                                          
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>