The directions for this are in the N4PY help file for the Pegasus Plus
program. Just search for "Using the RX-320, RX-340, Pegasus, or Jupiter
with the Omni VII".
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Richards"<jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
Sent: Friday, October 01, 2010 11:42 PM
Subject: Re: [TenTec] Omni VII
Hi Gary --- Are the directions for this in N4PY's README file?
I was holding off on doing this, myself, because I was under some
silly impression the modification was difficult and involved soldering
inside the radio, and I was not feeling up to doing that just yet (I am
building all of TT's receiver kits in order, and just finished
a bunch of Ramsey kits, and a keyer kit, but was squeamish about poking
around in my transceiver until I was a bit more adept, and it was a bit
older...
If it is as easy as you suggest, I might try it. If not in the README,
then is it on the TT Wicki or elsewhere?
THANKS LoADS. // K8JHR //
============================ JHR ===========================
On 10/1/2010 3:02 PM, CSM(r) Gary Huber wrote:
John,
I think the easiest way is to contact TenTec and ask for the cables for
the AUX Receiver modification for the 588. (No soldering or drilling
required)
==============================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec