The battery may be bad.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 9/22/2011 8:48 PM, Steve Berg wrote:
>
> Ever since I bought my Omni V.9, it had an intermittent frequency
> display. It would quit working, and then I would take the covers off
> and wiggle the connections, clean them and generally, I could get it
> working right again for a while. Earlier this year, it finally went
> from intermittent to not working at all, and so I pulled the board, and
> thinking that I might have a crystallized solder joint somewhere in it,
> carefully resoldered the entire display driver board. It still didn't
> work. So, I sent the board and eventually the entire radio back to the
> factory for repair. It came back with another display driver board, but
> it seems that the two digits from the far right of the display come up
> on the left side of the display when the radio is powered up. If I turn
> the radio off, and then turn it on while pushing in the red reset button
> on the right side of the radio, it generally goes to 14 MHz, and
> everything is fine until I shut it down and start it up again.
>
> Does anyone here have any idea of what might be causing this? If so, is
> there any reasonably easy fix for this problem?
>
> Steve WA9JML
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|