Hey, Scott. Don't bother trying my suggestion. Steve Hunt says it cannot
work.
----- Original Message -----
From: "Steve Hunt" <steve@karinya.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 21, 2011 7:51 AM
Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
Just follow the schematic!
Steve G3TXQ
On 21/11/2011 12:43, Mike Hyder -N4NT- wrote:
I believe, sir, that you are mistaken. I trust my experiences over your
opinion. But hey, why not try to discourage the fellow from trying a
very
simple test?
Mike N4NT
----- Original Message -----
From: "Steve Hunt"<steve@karinya.net>
To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
Sent: Monday, November 21, 2011 7:34 AM
Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
If the problem is still present when the Offset Tuning is off, it can't
be the balance of those pots. With the OT switched off, the *same* pot
signal is used both for Tx and for Rx.
73,
Steve G3TXQ
On 21/11/2011 04:27, Mike Hyder -N4NT- wrote:
Scott, I believe there is an internal pot which balances the RIT pot on
the
front panel. It sounds like it is not set correctly. Hope that's your
trouble for it's an easy fix.
73, Mike N4NT
|