TenTec
[Top] [All Lists]

Re: [TenTec] RX366

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] RX366
From: "Duane Calvin" <ac5aa1@gmail.com>
Reply-to: ac5aa@ac5aa.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 31 Jan 2012 10:02:21 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Are you describing hardware or software NR?  Each acts differently, and
hardware NR ("noise blankers") often has the side effect you describe.

        73, Duane 


Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com  

 

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of kc9cdt@aol.com
Sent: Tuesday, January 31, 2012 9:55 AM
To: tentec@contesting.com
Subject: Re: [TenTec] RX366

I find the NR is not very good here on the OII. Also the NB causes lots 
of clicking sound when a strong signal is ...well maybe within 10 KC or 
so.
I really wish it was better....so...I rarely find an instance that it 
helps...
Maybe I need to tweek some settings while using it??
But, I think I have tried everything, including RF gain settings, BW, 
ect.
73,
Lee



-----Original Message-----
From: Rsoifer <Rsoifer@aol.com>
To: tentec <tentec@contesting.com>
Sent: Tue, Jan 31, 2012 9:33 am
Subject: Re: [TenTec] RX366


I've tried them side by side, and found the "old" Orion II sub receiver
quieter than the Yaesu Mk V, due to the O II's DSP NR.  It would still 
benefit
 from a good roofing filter, though, so I plan to get the RX-366 when 
it's
available.

73 Ray W2RS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>