[TenTec] 566 Orion II Firmware Version V3.029 ---Comments

[Mike Stricker <info4mjs@yahoo.com>]

Hi,

I was wondering if anyone noticed that the spectrum display reads correctly on 
USB but is off a bit for CW and LSB modes.  When a signal on USB is tuned in 
properly, the peak on the display is right at '0'.  The peak is a bit to the 
left of '0' for CW and LSB...about 1.6KHz for LSB.  It reads low for CW and 
depends on whether the mode is UCW or LCW.

The audio distortion issue seems to have been resolved.

Thanks John.

Mike, WA1SEO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec