Bob,
Isn't SWR determined by the match between the feedline and the load and not
by resonance? I believe source amperage goes up when the impedance of the
load is lower than the source.
Please correct me if I'm wrong.
73..de John/K4WJ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of bob barnes
Sent: Sunday, March 03, 2013 6:30 PM
To: k9yc@arrl.net; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Herc II vs Astron
thats funny my 70amp switching power supply works just fine. i had my
doubts when i bought it but i bought it used and can always get my money out
of it. i have my omni 6 and the herk 2 both hooked up to it.
now the ant has to be resonate or the amperage will go up with a high swr.
73
bob
all things are possible in Christ Jesus our savior
--- On Sun, 3/3/13, Jim Brown <k9yc@audiosystemsgroup.com> wrote:
From: Jim Brown <k9yc@audiosystemsgroup.com>
Subject: Re: [TenTec] Herc II vs Astron
To: tentec@contesting.com
Date: Sunday, March 3, 2013, 4:14 PM
On 3/3/2013 12:06 PM, Richards wrote:
> Er... um... 70 amps...
In my experience, 70A is NOT enough. I've run my Herc II from TWO Astron
70A linear supplies, each connected to half of the output stages, and with
their regulator references tied together. That works fine. But only RS70 to
run the amp will go into protect mode.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|