TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Low Output on 12 and 15 m

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II Low Output on 12 and 15 m
From: Kim Elmore <cw_de_n5op@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 29 Jun 2013 09:44:44 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Nope, that's not it. It's into a 50 ohm dummy load and whether I not I use the auto turner, I get the same result.

Kim N5OP


On 6/29/2013 9:24 AM, John Bescher wrote:
Is there a chance that the SWR is higher on those bands so the Orion II reacts 
by less power?


John Bescher, N4DXI



-----Original Message-----
From: Kim Elmore <cw_de_n5op@sbcglobal.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Fri, Jun 28, 2013 11:17 pm
Subject: [TenTec] Orion II Low Output on 12 and 15 m


I have an Orion II  and have noticed over time that its output on the 15
and 12 m bands is lower than all the other bands on LCW, UCW and FSK.
With the PWR set to 100, the 160 through 20 m bands all show about 105 W
output using a 13.8 VDC power supply and a known accurate B&W 334A dummy
load. This output is stable regardless of whether the internal tuner is
used. Output on the 10 m band is 90 W, but on the 15 and 12 m bands,
output is about 70 W. also, the ALC indicator is NOT lit at the full
power output setting on either the 15 or 12 m bands, but IS lit on all
other bands. The ALC indicator will light on the 15 m band when the PWR
setting is adjusted down to 76 or below and when adjusted down to 84 or
below on the 12 m band. Any adjustment above this level results in the
ALC light being extinguished. On the 12 and 15 m bands any power output
is not affected until the PWR setting is at or below these levels. The
power indicator meter on the Orion II unit itself indicates about 95 on
all bands except 15 and 12 m. On 15 m it indicates 82 and on 12 m it
indicates about 88.

I had mentioned this earlier and had tried adjusting the internal ALC
level. This didn't affect the 12 or 15 m bands but did affect the
others. I exercised all of the plugs internal to the radio, but it made
no difference. Has anyone else experienced this? If so, what's the fix?

Kim N5OP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>