TenTec
[Top] [All Lists]

Re: [TenTec] OMNI 5 GOES DEAD ON 40

To: "n4py3@earthlink.net" <n4py3@earthlink.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI 5 GOES DEAD ON 40
From: Wade Staggs <tvman1954@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 10 Feb 2015 23:15:35 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
*O.K. I will be the first one to ask. Has nobody figured out yet where the
positive and negative battery terminals are on this RAM Chip? Maybe I have
just ask the Stupidest Question, ever ask on this forum. I have never seen
one of these RAM Chips. Can somebody please send me a picture of an example
Chip? It just seems to me that some fine wire leads and a battery holder
with the correct voltage of batteries installed, could place an end to the
whole problem. Aw Shucks, you could even install a small solar cell
illuminated from an Ironman or Batman 7 watt nightlight ..... hi .. hi ...
This is a good question ( I Hope ) Maybe the Internal Battery shorts to
Zero Ohms? So that an outboard battery won't work? *
*      As Johnny 5 Says .... Need Input !! 73 from Wade/KJ4WS*

On Tue, Feb 10, 2015 at 9:35 AM, Carl Moreschi <n4py3@earthlink.net> wrote:

> The battery backed up RAM in the Omni V does not use the battery.  It uses
> a RAM chip with a built in internal battery that cannot be changed.  These
> chips were made many years ago with 10 year life lithium batteries in
> them.  You can possibly buy a new one but even the new ones are more than
> 20 years old and their internal batteries might also be bad.
>
> The 40 meter problem is most likely the 40 meter crystal.  When I had my
> Omni V I found that I could adjust the trimmer on the 40 meter crystal and
> make it run.  I ended up with about a 2 khz frequency error on 40 meters
> but it worked.  My N4PY Omni V ship has a setup for recalibrating in
> software and this solved my 40 meter problem.  But your battery backed up
> RAM chip may not be as easily solved.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
> On 2/10/2015 10:19 AM, gary mankoff wrote:
>
>> OMNI 5 GOES DEAD ON 40 METERS AFTER 1 HOUR AND WILL NOT HOLD MEMORY OF
>> LAST
>> FREQ USED EVEN WITH NEW BATTERY... ANY HELP WOULD BE APPRECIATED...
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>  _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>