AND they nipped the through hole leads on the parts too short…
Gary’ W0DVN
> On Jan 20, 2016, at 8:43 PM, Bwana Bob <wb2vuf@verizon.net> wrote:
>
> I believe that they redesigned the PLLs for the Paragon II. The main issue
> with the PLL boards in the original Paragon was poor tinning of the component
> leads and the PWB.
>
> 73,
>
> Bob WB2VUF
>
> On 1/19/2016 9:29 PM, Gary J FollettDukes HiFi wrote:
>> I can’t speak insider facts here but I have had many Paragon 2 radios and
>> none of them had PLL issues.
>>
>> Gary
>>
>>
>>
>>> On Jan 19, 2016, at 5:17 PM, steve jobes via TenTec <tentec@contesting.com>
>>> wrote:
>>>
>>> I have not had any problems with my paragon 2, and can't recall hearing of
>>> any issues with them.
>>>
>>> 73,
>>> Steve W1DXH
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>> -----Original Message-----
>>> From: k7mks <k7mks@comcast.net>
>>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>>> Sent: Tue, Jan 19, 2016 6:14 pm
>>> Subject: [TenTec] Paragon vs Paragon II - PLL
>>>
>>> Did Ten Tec make any performance improvements (ie soldered board
>>> conections, etc) in the later #586 PLL over the earlier #585 PLL's ?
>>>
>>> Thank you. joe k7mks
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|