TenTec
[Top] [All Lists]

Re: [TenTec] Ear Phone Audio

To: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ear Phone Audio
From: Gary Follett <dukeshifi@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Aug 2016 13:32:51 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes, and the peak to peak available output from an Orion, about 13 volts p-p, 
should produce head banging volume in virtually any headphone if working 
properly, even the old "cans" from the 1930's.

You need to be looking at things that can affect both channels of the output 
since, at this point in the circuit, the thing is operating in stereo. This 
precludes defective dropping (ear protection) resistors or wiring problems. It 
is looking like the headphone amp output is defective.

Gary

Sent from my iPad

> On Aug 24, 2016, at 12:32 PM, Jim Brown <k9yc@audiosystemsgroup.com> wrote:
> 
>> On Wed,8/24/2016 10:08 AM, Robert P. Santella wrote:
>> Impedance needs to be 30 ohms.
> 
> NO! Headphone impedance is NOT critical. Audio power amplifiers are VERY 
> different from RF power amplifiers. Virtually all audio amplifiers are low 
> impedance sources, and are designed to drive any impedance greater than a 
> design minimum. For example, the source impedance of a loudspeaker output 
> stage is a small fraction of an ohm, and is designed to drive any loudspeaker 
> load greater than 4 ohms. The relationship between these two impedances is 
> called the "damping factor," and 100 is a typical value. A well-designed 
> headphone amp will include a low-value resistor in series to protect the 
> amplifier from being shorted when headphones are being plugged and unplugged.
> 
> Most modern headphones are in the range of 20 - 300 ohms, and a well-designed 
> headphone amp should drive all of them just fine. What matters a lot more is 
> voltage sensitivity, and headphone mfrs generally get that right too. Many 
> years ago, I carried around a set of crystal headphones in my toolkit when I 
> worked on troubleshooting audio systems in buildings. They were sensitive 
> enough that I could hear (weakly) the signal of an unamplified microphone, 
> yet the impedance was high enough that they didn't load most circuits!
> 
> 73, Jim K9YC
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>