that seems to have worked…time will tell..thanks so much om.
> On Feb 26, 2017, at 7:21 AM, Carl Moreschi <n4py3@earthlink.net> wrote:
>
> Have you done all 3 resets to the Orion?
>
> 1) Power off Orion.
>
> 2) Power On holding the VFO B LCK button.
>
> 3) Continue holding LCK button until the radio says "Battery Failure".
>
> 4) Power off Orion.
>
> 5) Power on holding "Main RX/TX" button.
>
> 6) Continue holding this button until the radio says reset complete.
>
> 7) Do not clear any settings when asked to do so.
>
> 8) Power the Orion off and back on one more time.
>
>
>
> 73,
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 2/26/2017 10:17 AM, denton sprague wrote:
>> ran across something that seems to be affecting the sub receiver in my Orion
>> 1.
>>
>> If I boot the rig after I turn on its power supply, the sub receiver kicks
>> in normally.
>>
>> If I reboot the rig after leaving it connected to its power supply, which
>> has been left on, the sub receiver will not kick in.
>>
>> If I leave the onions on/off switch in on position and use the power
>> supply’s on/off switch to turn the rig on and off, the sub receiver performs
>> normally.
>>
>> Orion has fresh memory battery and power distribution board cap replacements.
>>
>> Also, the display wants to get a bit dim after the rig has run for an half
>> hour or so…and I notice it gets a little warm. Thinking of pulling the
>> speaker and installing a 12 vdc fan in its stead to see if that has any
>> effect.
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|