[Top] [All Lists]


To: <tentec@contesting.com>
Subject: [TenTec] PARAGON MUTE
From: "Bob Good" <k4bg@planters.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 15 May 2018 16:14:23 -0400
List-post: <mailto:tentec@contesting.com>
In celebration of my 60th anniversary in Ham Radio, I have finished the 
overhaul of my Heath DX-100 transmitter to have some fun on classic radio AM 
mode.  I want to use my T-T Paragon 585 transceiver as my AM Receiver in 
conjunction with my DX-100.  I have built the “traditional” outboard antenna 
transfer relay with an auxiliary spst shorting mute output for use with the 
DX-100.  Now I find that the Paragon has NO provision for muting the receiver 
externally.  I am concerned about damaging the front end of the receiver with 
the DXC-100 output.  I doubt simply grounding the “antenna” jack on the Paragon 
would be adequate protection.  I therefore ask for this group’s knowledge and 
expertise as how to approach any needed modification or procedures required.  
Thank you for your assistance.  QRZ Info is current.  Regards,  Bob K4BG
TenTec mailing list
<Prev in Thread] Current Thread [Next in Thread>