TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI opt 3.... PLL problem

To: Ten-Tec List <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI opt 3.... PLL problem
From: Jim Goudie <jagoudie@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Jan 2022 17:44:22 -0500
List-post: <mailto:tentec@contesting.com>
Pete,

Thanks!  I saw a reference today stating that these boards “in the oven” often 
have solder joint problems, which makes me think that my be heat related, as 
well.

I appreciate this additional information.  I only have a 20 mhz scope, but I 
know people!  ;-)

Thanks again!!
Jim  AF3Z

Jim Goudie   —  jagoudie@comcast.net
610 Kraybill Church Rd
Mount Joy, PA 17552

> On Jan 28, 2022, at 1:43 PM, Peter Bertini <radioconnection@gmail.com> wrote:
> 
> *To*: tentec@contesting.com
> *Subject*: Re: [TenTec] Omni VI warbling sound
> *From*: Peter Bertini <radioconnection@gmail.com>
> *Reply-to*: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> *Date*: Wed, 26 Dec 2018 09:15:59 -0500
> *List-post*: <mailto:tentec@contesting.com <tentec@contesting.com>>
> 
> That warbling   can also be caused by a HFO crystal that is trying to phase
> lock to the master oscillator. The PLL will sweep the oscillator loop
> voltage trying to achieve a locked condition.
> 
> I've had problems with a few (three) of my Omni VI rigs developing problems
> with the oscillators on the 81595 LO Mixer Board. If the problem is not in
> your VFO PLL,  look at the lock signal on Pin 11 of U13 on the CPU board.
> It should be a very narrow negative pulse (100 MHz scope, fastest scan
> rate) and stable.  Oscillators are adjusted for minimal pulse width.  If an
> oscillator is out of lock, you will see a lot of jitter on pin 11.
> 
> If anyone who has found a cure for this issue I'd appreciate hearing from
> you. It appears to be heat related, as the crystals age the board becomes
> very heat sensitive, and the board is in encased in what is basically an
> oven which adds to the problem.
> 
> Pete
> _______________________________________________
> TenTec mailing list
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>