Towertalk
[Top] [All Lists]

Rohn 25 bolts

To: <towertalk@contesting.com>
Subject: Rohn 25 bolts
From: n4si@techinter.com (n4si)
Date: Tue, 17 Dec 1996 03:55:59 +0000
> I need to replace the bolts in a  25G tower. I need to find a better type of
> bolt, that won't rust so quickly. The Rohn tower doesn't mention what type of
> bolts to use. Since the stock Rohn bolts didn't last too long, I was thinking
> about stainless. Is there a problem with this? What is the correct size?
> 
> Thanks / Happy holidays,
> 
> Will 
> 

I think the Rohn bolt kits are the best way to go. They are
relatively inexpensive, (certainly less so than SS) and the "right"
ones. The bolt sizes are 5/16" and 1/4" x 1 1/2 (I think; the 5/16
and 1/4 is correct, it's the length I'm not positive on), but more
importantly they are SAE (National Fine) thread. 

That has implications both for tightening and later removal after a
rust coat has formed. I have never been unable to back a nut off  a
5/16 bolt, and most 1/4 inch ones. In contrast, I have never failed
to break a 1/4 NC (National Coarse, not North Carolina!) bolt that
has been up a while.

Rohn bolts are galvanized.

A larger question is why do you need to replace them? If you are 
re-erecting a used tower, then I highly recommend re-bolting with 
Rohn kits. If the bolts have become structurally unsound due to rust, 
then I would be suspicious of the whole array.

Stainless Steel can never be torqued to as high a value as steel due 
to the galling and subsequent stripping of threads.

73, Rod N4SI
    The DXer formerly known as N9AKE
         (c) 5 November, 1996

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>