Towertalk
[Top] [All Lists]

Tower Ratings - Stupid Question

To: <towertalk@contesting.com>
Subject: Tower Ratings - Stupid Question
From: robrk@fyi.net (Bob Morris K2RK)
Date: Thu, 19 Dec 1996 22:09:53 -0800
K7LXC@aol.com wrote:
> 
> In a message dated 96-12-19 18:17:22 EST, you write:
> 
> >I am also trying to study the tower literature for an installation
> >next year.  I have had a comment that at least one manufacturer
> >(is it Tri-ex?) states that their crank-up sections are specially
> >strengthened in the area of the overlap.
> >In this case the tower is weakened if the owner lowers it half-way
> >down, under storm conditions?
> >
>       The forces on a crankup are obviously at their maximum when the tower
> is fully extended.  Having the overlap areas beefed up is a good thing to do
> since most hams load their towers to the max and leave them extended.  When
> the tower is lowered, the overall forces are reduced because there is less
> surface area exposed and there is less moment of force on it.  If you have a
> tower with a  load that exceeds the wind speed rating, you can lower the
> tower an amount (that you have to determine) until you reach a height that is
> safe for that wind load and speed.
> 
> 73,  Steve  K7LXC
> 
>     TOWER TECH -- professional tower supplies and services for amateurs
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 K7LXC@contesting.com
> Sponsored by Akorn Access, Inc & KM9P

I hear people putting guy wires on self-support or crank-ups,
thinking they are improving wind load etc...
Is this not a -bad thing-?

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>