Towertalk
[Top] [All Lists]

HAM-4 ROTOR TROUBLESHOOTING ADVICE

To: <towertalk@contesting.com>
Subject: HAM-4 ROTOR TROUBLESHOOTING ADVICE
From: ve6jy@freenet.edmonton.ab.ca (Don Moman)
Date: Mon, 6 Jan 1997 10:12:23 -0700 (MST)
If the rotor starts ok, then stalls randomly I doubt it's the capacitor. 
Replacement caps - bigger isn't better so stick to the same capacity value
(or close to it). With a test jig in line and measuring motor current
while different caps are put in the circuit, it is quite apparent that a
larger value of the capacitor will increase the current flow drastically.
With the rotor running fine with the proper cap, adding another cap of the
same size caused the rotor to stall and/or become very sluggish.  

Here anyway, most available motor starting caps are for 120 or 240 vac and
a value in 120 -140 mfd range isn't common, most are much smaller. 

73 Don



VE6JY is Don Moman             email: ve6jy@freenet.edmonton.ab.ca
Box 127 Lamont, Alberta T0B 2R0 (403) 895-2925



--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>