Mai qoi, mon ami...cut the z section in the center, and bend both pieces
outward until you
get the rotor in, then bend the sections back in place and place a 6" section
of (hopefully
a bad section of a tower piece not in use ) z bracing equally across the cut,
get LARGE
cable clamps and join it back up.
Get a galvanized 6" bolt if you don't have a trashy tower section. Make it same
size as
z section, and goto step 1
73,
Ed
-------------------------------------
Name: Ed Sleight
E-mail: k4sb@avana.net
To: <towertalk@contesting.com>
Date: 1/28/97
Time: 6:14:13 PM
-------------------------------------
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & N4VJ / K4AAA
|