Towertalk
[Top] [All Lists]

[TowerTalk] Trimming 75 ohm hardline

To: <towertalk@contesting.com>
Subject: [TowerTalk] Trimming 75 ohm hardline
From: zettel@homer.libby.org (Steve Zettel)
Date: Wed, 13 Jan 1999 19:17:45 -0700
A question for the combined wisdom of the reflector:

I was trimming some 75 ohm hardline, 1/2" Commscope variety, to get a half wave 
at 7.0 mHz so I could feed my stacked F12 C-3E tribanders at something 
resembling 50 ohms on the even harmonics. I am terminating one end with a 50 
ohm non-inductive resistance, the other end I've terminated in a plumber's 
special to PL-259 fitting. I am measuring SWR with an Autek RF-1 Analyst; I am 
not measuring in any strong BCB or other RF fields that I am aware of.

I started off quite a bit longer than the length predicted by the formula:

         1/2 X WL X VF
 
I've got a 1:1 SWR right now falling between 7.00 and 7.3 mHz, although 
centered somewhat higher than I'd like around 7.175 mHz; and 1:1 points falling 
in the 20, 15, and 10M bands, too. This is at 232 feet of hardline. 
Interestingly, there is a 1:1 SWR point below 7.175 mHz at around 6.1 mHz. Does 
this indicate that I should continue to trim until I've "raised" this lowest 
1:1 SWR point to 7.025 mHz, or leave well enough alone? At 232' I'll have some 
excess to coil up and I can live with that; what I don't want to do is cut the 
hardline too short and have to splice some back in.

Thanks for the hand-holding,

Steve Zettel  KJ7CH
near Libby, MT USA 

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>