Towertalk
[Top] [All Lists]

[TowerTalk] Help with beam rotation

To: <towertalk@contesting.com>
Subject: [TowerTalk] Help with beam rotation
From: K7LXC@aol.com (K7LXC@aol.com)
Date: Tue, 9 Mar 1999 17:47:37 EST
In a message dated 99-03-09 15:44:09 EST, rtudor@att.net writes:

<< I have a TH7 at 40 feet in a Ham IV. I am on the top of a hill at 2000 feet
 ASL. I get a lot of high winds. The beam gets off the correct heading in the
 strong winds.
 
 My question - should I pin the mast to the rotator to stop the rotation? I
 am not sure if I would cause a problem to the rotator.  >>

      My suggestion is to NOT pin it. The problem is that those wind forces
will find the next weak link in the system; in this case, either the ring gear
or brake. It's much easier and cheaper to realign the antenna occasionally
than swap/repair rotators. 

      The neck of the T2X has a hole that you can use to pin the mast if you
choose - the Ham IV does not. The Ham IV also uses smaller U-bolts so it
doesn't have the holding power that a T2X does. 

       What can you do? You could try some thin rubber material between the
mast and clamp although I think that some TowerTalkians have found this to be
unsatisfactory. One fix that I think did work was to apply some ScrewGrab
where the metal to metal contact is. ScrewGrab is a marvelous tool - it's got
little diamond-shaped material in suspension. It'll increase friction by 400%
and is VERY usefull for removing stripped screws and nuts. Just put a drop or
two where you need the friction and your problem will be solved. It's five
bucks for a tube from Champion Radio Products - http://www.championradio.com.

Cheers,   Steve   K7LXC
Champion Radio Products

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>