Towertalk
[Top] [All Lists]

[TowerTalk] [Tower Talk] 10 to 25 ohm feed.

To: <towertalk@contesting.com>
Subject: [TowerTalk] [Tower Talk] 10 to 25 ohm feed.
From: K7GCO@aol.com (K7GCO@aol.com)
Date: Fri, 12 Oct 2001 05:13:27 EDT
In a message dated 10/11/01 10:58:01 AM Pacific Daylight Time, 
info@cal-av.com writes:

<< Ken and all -
 As a matter of interest, the W.W.II wideband, high power balun built into
 the hairpin is used on the (current production) 2D-series of antennas mfg.
 by CAL-AV.  See www.cal-av.com/antennas.html
 73,
 Ken
 ----- Original Message -----
 From: <K7GCO@aol.com>
 To: <towertalk@contesting.com>; <longterm@chatusa.com>
 Sent: Wednesday, October 10, 2001 9:11 PM
 Subject: Re: [TowerTalk] [Tower Talk] 10 to 25 ohm feed.
  >>
Thanks for the input.  Over the years I've been more and more acceptive of 
the hairpin match.  For years I was againt any reduction of the high current 
area being canceled from radiating in a hair pin.  But in Eznec I've run many 
patterns where the DE was less than a 1/2 wave and more than 1/2 wave and 
there was virtually no change in the pattern.   There can be a bandwidth 
difference but with a short 50 ohm hairpin it's very close.  No balun is 
needed if the coax is run up one side of the hair pin, any R value can be 
obtained and there is nothing to saturate.  It's a pretty good match although 
not my favorite.  k7gco

List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>