Towertalk
[Top] [All Lists]

Re: [TowerTalk] ? AMERITRON REMOTE COAX SWITCH

To: "Bill VanAlstyne" <w5wvo@cybermesa.net>,<towertalk@contesting.com>
Subject: Re: [TowerTalk] ? AMERITRON REMOTE COAX SWITCH
From: Pete Smith <n4zr@contesting.com>
Date: Fri, 30 Apr 2004 06:43:14 -0400
List-post: <mailto:towertalk@contesting.com>
At 12:22 AM 4/30/04, Bill VanAlstyne wrote:

I own this switch -- the model equipped with UHF connectors. It is also
available with N-type connectors. I've found that the switch remains relatively
"flat" well up past 50 MHz -- I feed my 6M yagi through one -- but somewhere
above that, it starts to introduce a measurable but modest amount of line
mismatch, loss, and increased SWR. This degradation just starts to be noticeable
at 144 MHz on my setup. I don't have 220 MHz capability, but at 440 MHz the
switch is really unusable. Of course they don't claim it will operate at 70 cm,
but since the degradation is noticeable at 2M, I would have to be skeptical of
Ameritron's claim of usability up to 250 MHz until I actually tried it there and
measured the degradation. Of course how much loss and SWR increase is tolerable
to someone is a subjective matter.


As regards contact cleaning, the guy who probably designed this box is on this
reflector, so he can chime in and address that question if he wants to. Relay
contacts, however, if they are designed and aligned properly, are self-wiping.
You shouldn't need to worry about cleaning them. (With any luck, we'll find out
if I'm right about that.)



The current MFJ catalog's write-up on the RCS-8V is a little confusing. The first paragraph says you can control it with standard telephone wire, which is 4-conductor, while later on in the ad it says that it needs a 6-conductor cable. This matters because I remember W8JI writing about a design change to using BCD control, to reduce the number of wires involved. If this has been done on the RCS-8V, and if it uses simple relay decoding of the BCD signal, then the internal signal path must be quite different than in earlier models. From the description, the RCS-10, which uses a 3 or 4 conductor control line to select one of 8 antennas, must use BCD control, but I don't know whether they use an IC to decode the signals or use the relays. If Tom's reading this, perhaps he can clarify.


73, Pete N4ZR
The World HF Contest Station Database
was updated on April 26, 2004
2706 contest stations at
www.pvrc.org/WCSD/WCSDsearch.htm


_______________________________________________

See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>