I would consider that an almost permanent solution, not something temporary
I guess. That is about what I do for a permanent install except there is a
coat or two of Scotchcote in there.
One thing that does make it easier if you are removing the stuff is to do
the first layer of tape sticky side out. Once you get the hang of this, it
works pretty well and it is very easy to get that inner layer of tape off
since it isn't stuck to the connectors and coax.
Good Luck
Daron J. Wilson, RCDD
System Integrator
LH Morris Electric
541-265-8067 office
775-310-0446 direct
775-659-9350 fax
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of W0UCE
Sent: Tuesday, February 08, 2005 12:27 PM
To: 'towertalk reflector'
Subject: [TowerTalk] Coax Connector Sealing Another Alternative
Haven't yet seen anyone mention a single layer of electrical tape, a
layer of Coax Seal and a final layer of electrical tape. Easy, long
lasting and not difficult to remove if or when needed.
???WØUCE
Homepage Website
?www.w0uce.net
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|