Towertalk
[Top] [All Lists]

Re: [TowerTalk] 10 Meter Beams - Any IDEAS

To: towertalk@contesting.com
Subject: Re: [TowerTalk] 10 Meter Beams - Any IDEAS
From: "larryjspammenot@teleport.com" <larryj@teleport.com>
Reply-to: "larryjspammenot@teleport.com" <larryj@teleport.com>
Date: Sun, 8 Jan 2006 19:24:47 -0800 (GMT-08:00)
List-post: <mailto:towertalk@contesting.com>
George, I'd like to know about how you fed the quad with two separate feedlines 
and did the switching between the two feedlines to get the separate polarities. 
I see a need for both polarities at my place - the vertically-polarized locals 
that hang out on 10M SSB mobile and the FM guys with groundplanes, and then the 
usual CW/SSB operations where horizontal polarization is needed. I had been 
planning to put up two separate quads on different masts here to cover both 
situations. I've been using my quad for SSB/CW, and then a Butternut vertical 
antenna for local SSB and FM. One antenna with some gain to cover both 10M 
situations would be nice.

LJ



-----Original Message-----
>From: "George P." <ab2kc@optonline.net>
>Sent: Jan 8, 2006 6:39 PM
>To: K4SAV <RadioIR@charter.net>, towertalk@contesting.com
>Subject: Re: [TowerTalk] 10 Meter Beams - Any IDEAS
>
>Gents,
>I would not feed only with vertical... That would make no sense to me. Feed 
>Both polarities with separate feedlines!!! Then you can choose either, or 
>both with phase shift if you want to play with circular. I have compared the 
>vertical and horizontal patterns independently on my quad and found that at 
>50 feet to the boom, they are very close. At less than 36 feet (<1 
>wavelength, no tests were done) I would think the horizontal polarization 
>would be more affected, since the elements are in the same plane as the 
>ground. BTW... Both have >30 dB front to back and a little more off the back 
>corners (4 elements) at 50ft with my design. Gain of the vertical feedpoint 
>on the quad over the antron99 is about 10/12dB. I had no dipole to compare 
>for the horizontal polarization gain comparison test.
>George AB2KC
>
>----- Original Message ----- 
>From: "K4SAV" <RadioIR@charter.net>
>To: <towertalk@contesting.com>
>Sent: Sunday, January 08, 2006 9:10 PM
>Subject: Re: [TowerTalk] 10 Meter Beams - Any IDEAS
>
>
>> OK, I'll concede one point.
>>
>> If your interested in local ground wave contacts, then the fact that you
>> lose most of the antenna gain with a vertically polarized quad, probably
>> doesn't matter.  But I don't think it's the kind of thing a contester
>> would be interested in doing.
>>
>> Jerry, K4SAV
>>
>> K4SAV wrote:
>>
>>>I would not recommend feeding an HF quad with vertical polarization. If
>>>you do that, the antenna pattern is no longer reinforced by ground
>>>reflections, and you end up with something that has less than free space
>>>gain.  If you have a UHF antenna that is far enough above ground to not
>>>care about ground reflections, then maybe it doesn't matter.
>>>
>>>Jerry, K4SAV
>>>
>>>George P. wrote:
>>>
>>>
>>>
>>>>Michael,
>>>>Quads rule. 4 elements minimum and you'll be on top. Set driven element 
>>>>up
>>>>for both vertical AND horizontal. Use same feedline length for each
>>>>polarity, and you can play with circular polarization if you add 90 
>>>>degrees
>>>>phase length (1/4W) in one of the feedlines. Vertical is great for late
>>>>night ground wave for mobile contacts, state to state  <200 miles and the
>>>>local repeaters. You may e-mail me for more info on how to set it up. 
>>>>When
>>>>the band dies... there's always guys on groundwave using A99 verticals.
>>>>George AB2KC
>>>>
>>>>----- Original Message ----- 
>>>>From: "Michael Mark" <m2eng@mts.net>
>>>>To: <towertalk@contesting.com>
>>>>Sent: Friday, January 06, 2006 8:32 PM
>>>>Subject: [TowerTalk] 10 Meter Beams - Any IDEAS
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>>I like contesting and have the Canadian 10M Phone LP SSB record which I 
>>>>>did
>>>>>in 1991 with about 2500 QSO's.
>>>>>
>>>>>I used a Hy Gain LJ105 on a 48' tower back then at my old QTH.
>>>>>
>>>>>I have a couple of bucks now so I want something better for the upcoming
>>>>>Sunspot Cycle increase.
>>>>>
>>>>>I have a 48' tower at my office building with nothing on it.
>>>>>
>>>>>As well, my flat building roof is 65' x 45' with 16' in height.
>>>>>
>>>>>I have new: A Stack Match for 2 antennas, new Ham IV and 2 Hy Gain
>>>>>LJ105CA's and a Glen Martin 8' Roof tower.
>>>>>
>>>>>I was also considering a M2 10M7 or a Force 12 MAG 810 as well.
>>>>>
>>>>>Just asking for some ideas or experiences from you Contesters about your
>>>>>10M antenna recommendations.
>>>>>
>>>>>Tnx
>>>>>
>>>>>Michael Mark, P.Eng., VE4MM
>>>>>_______________________________________________
>>>>>
>>>>>
>>>>>
>>>>>_______________________________________________
>>>>>TowerTalk mailing list
>>>>>TowerTalk@contesting.com
>>>>>http://lists.contesting.com/mailman/listinfo/towertalk
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>_______________________________________________
>>>>
>>>>
>>>>
>>>>_______________________________________________
>>>>TowerTalk mailing list
>>>>TowerTalk@contesting.com
>>>>http://lists.contesting.com/mailman/listinfo/towertalk
>>>>
>>>>
>>>>
>>>>
>>>>
>>>
>>>_______________________________________________
>>>
>>>
>>>
>>>_______________________________________________
>>>TowerTalk mailing list
>>>TowerTalk@contesting.com
>>>http://lists.contesting.com/mailman/listinfo/towertalk
>>>
>>>
>>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> 
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>