Towertalk
[Top] [All Lists]

Re: [TowerTalk] homebrew low voltage surge suppressors?

To: "K4SAV" <RadioIR@charter.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] homebrew low voltage surge suppressors?
From: "Dubovsky, George" <George.Dubovsky@andrew.com>
Date: Wed, 27 Sep 2006 16:26:56 -0400
List-post: <mailto:towertalk@contesting.com>
I measured one of their ICE 303 units years ago, and the inductor was 44
uH.

73,

geo - n4ua

> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of K4SAV
> Sent: Wednesday, September 27, 2006 4:15 PM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] homebrew low voltage surge suppressors?
> 
> ..."Their use of a coil across the line is also questionable."...
> 
> -----------------------
> Now that you mention it, I may as well give you the answer.
> 
> I don't know the value of the inductor they use, but a little circuit
> analysis can ballpark the value.  They claim these suppressors operate
> to 1.5 MHz, so in order to keep the SWR under 1.2 at 1.5 MHz, the
> inductor has to be at least 30 uH.  When you take a 30 uH inductor and
> place it in SPICE and drive it with a typical 8/20 us lightning
waveform
> at 20,000 amps, the voltage across the inductor goes to about 74,000
> volts. So the inductor isn't doing much by itself.

------------------------------------------------------------------------------------------------
This message is for the designated recipient only and may
contain privileged, proprietary, or otherwise private information.  
If you have received it in error, please notify the sender
immediately and delete the original.  Any unauthorized use of
this email is prohibited.
------------------------------------------------------------------------------------------------
[mf2]
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>