Hi Gentlemen:
Thanks to Steve's good advice, I checked the alignment of the Rohn 45
sections I have and found that some sections are out of alignment by
almost 1/4". Some of this tower was left over from a project up in
Seattle, and I suspect that it may have been put aside as not well
fitting, but I'm not sure. I think N2EA mentioned a while back on this
list that he had to have a section cut apart and re-welded. I hope I
don't have to do that. I am tempted to try and bend the ends a little
with a jack or something to make things align, especially on one section
that looks a little bent already (in the wrong direction). What advice
do you have for me?
73,
Rob, KL7NA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|