Towertalk
[Top] [All Lists]

Re: [TowerTalk] How To Cut "Slits" In Aluminum Tubing?

To: "'Marshall Stewart KA5M'" <marsh@ka5m.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] How To Cut "Slits" In Aluminum Tubing?
From: "Randy" <hamradio@oz.net>
Reply-to: hamradio@oz.net
Date: Sun, 8 Jun 2008 15:48:29 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hack saw?


********************************


-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Marshall Stewart KA5M
Sent: Sunday, June 08, 2008 3:11 PM
To: towertalk@contesting.com
Subject: [TowerTalk] How To Cut "Slits" In Aluminum Tubing?

What is the best way to cut "slits" in the end of an aluminum tubing antenna
element to allow it to be compressed enough with a hose clamp to fit tightly
on the next smaller size tubing telescoped inside?

Marsh Stewart, KA5M 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>