Towertalk
[Top] [All Lists]

[TowerTalk] Older TX2 repair

To: <towertalk@contesting.com>
Subject: [TowerTalk] Older TX2 repair
From: "Russell Hill" <rustyhill@earthlink.net>
Date: Tue, 14 Oct 2008 15:06:34 -0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hello, All:

My older CDE TX2 is is stalling after only a few degrees of movement in 
either direction, and the direction indicator quit moving.

I checked all the voltages and resistances in the controller, all good, and 
made the same checks on the rotor itself, also all good.

I took upper bell off the rotor, removed the upper ball bearing retainer, 
found the spur and pinion gears resisting movement after a few degrees. 
Then I removed the ring gear, so the motor and gear train could move freely.

In this configuration the motor would turn a bit in one direction before 
stalling,and might turn a bit in the other direction, or would stall in 
either direction without moving.  I made sure the stop lever was not making 
contact in either direction.  I could hear the electric motor trying to run, 
but not making it.

Also, the wipe arm on the pot on top is not turning, even when the motor was 
moving before stalling.  If I moved the arm on the pot the controller 
direction indicator works just fine.

I conclude the motor is toast, possibly because the shaft in the motor is 
broken or damaged.

At this point I have gone as far as I feel qualified to go.  This seems to 
be more than just a loose connection or an easily accessible gear 
replacement.

Before I ship it off to Starkville for factory repair, does anyone have any 
suggestions?  Or will Hy-Gain, Starkville, even work on the older CDE units? 
Should I do anything else?  Does someone else work on these older units, 
perhaps a ham supporting his hobby?

Thanks,
Rusty, NA5TR 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>