Towertalk
[Top] [All Lists]

Re: [TowerTalk] Keeping stranded center conductors from expanding

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Keeping stranded center conductors from expanding
From: Mark Spencer <mspencer12345@yahoo.ca>
Date: Wed, 7 Jan 2009 07:16:43 -0800 (PST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks.    I will try this.

Regards

Mark
VE7AFZ



----- Original Message ----
From: Kimo Chun <kimo@lava.net>
To: towertalk@contesting.com
Sent: Tuesday, January 6, 2009 12:36:38 PM
Subject: [TowerTalk] Keeping stranded center conductors from expanding

In situations where I wanted to keep stranded coaxial center conductors
perfect I will cut down to the center conductor further down the dielectric
than normal. Then rather than sliding the dielectric all the way off as is
customary I slide it part way so it still captures the end of the center
conductor and doesn't allow it to change orientation. Then I allow some
solder to soak into the strands to lock them in place. Then I pull the
dielectric the rest of the way off and trim the conductor with cable cutters
(not diagonal cutters) through the solder area. The strands remain perfect
as if still encapsulated in the dielectric. This works so long as you can
tolerate the addition of the solder.



Some dielectrics are rather stiff (non-foam types) and are formed in a
spiral following the conductor. With these you may have to unscrew the
dielectric off to keep the center conductor true.



Kimo Chun, KH7U





Message: 1

Date: Tue, 6 Jan 2009 05:08:31 -0800 (PST)

From: Mark Spencer <mspencer12345@yahoo.ca>

Subject: Re: [TowerTalk] Crimper for Belden 9913 - Response DAVIS RF

    Co.

To: "Steve Davis -Davis RF Co." <sdavis@davisrf.com>

Cc: towertalk@contesting.com

Message-ID: <298796.30445.qm@web38804.mail.mud.yahoo.com>

Content-Type: text/plain; charset=iso-8859-1



Sorry not sure what happened with the formatting here..? I'll try again..





Steve With regards to the center conductor expanding if it is cut after
removing the dielectric, I have noticed this with 9913F7 as well.



Is there a special tool or technique that can be used to minmize this Best
regards Mark VE7AFZ





_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



      __________________________________________________________________
Be smarter than spam. See how smart SpamGuard is at giving junk email the boot 
with the All-new Yahoo! Mail.  Click on Options in Mail and switch to New Mail 
today or register for free at http://mail.yahoo.ca
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>