Towertalk
[Top] [All Lists]

Re: [TowerTalk] pipe tap drill size

To: "'Tower and HF antenna construction topics.'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] pipe tap drill size
From: "Jan Wise" <Wisecrafter@suddenlink.net>
Reply-to: wisecrafter@suddenlink.net, "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Thu, 11 Mar 2010 13:09:13 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I don't have a chart, but it takes a #7 drill bit.

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of r miles
Sent: Thursday, March 11, 2010 1:06 PM
To: antennas; towertalk
Subject: [TowerTalk] pipe tap drill size

I am putting two gusset plates to hold truss supports on my homebrew 30m
Moxon. I'm using 1/4'' X 20 bolts. It's  been 40 yr.s since I worked in a
machine shop. Don't have the proper hole size chart  for taps anymore.  I
assume the hole size to be threaded 1/4 x 20 is less than 3/16''. Anyone
have a chart showing the proper size.TNX
K9IL
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4936 (20100311) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com


 

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4936 (20100311) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com
 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>