Towertalk
[Top] [All Lists]

Re: [TowerTalk] pipe tap drill size

To: "Tower and HF antenna construction topics." <towertalk@contesting.com>, "antennas" <antennas@mailman.qth.net>
Subject: Re: [TowerTalk] pipe tap drill size
From: "Penninger Radio" <charles@penningerradio.com>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Thu, 11 Mar 2010 13:30:06 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The drill size is a #7 drill (.201")
Charles, KC9DAO
Penninger Radio
^
^
----- Original Message ----- 
From: "r miles" <greenacres113@charter.net>
To: "antennas" <antennas@mailman.qth.net>; "towertalk" 
<towertalk@contesting.com>
Sent: Thursday, March 11, 2010 1:05 PM
Subject: [TowerTalk] pipe tap drill size


>I am putting two gusset plates to hold truss supports on my homebrew 30m 
>Moxon. I'm using 1/4'' X 20 bolts. It's  been 40 yr.s since I worked in a 
>machine shop. Don't have the proper hole size chart  for taps anymore.  I 
>assume the hole size to be threaded 1/4 x 20 is less than 3/16''. Anyone 
>have a chart showing the proper size.TNX
> K9IL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>