Thanks!
________________________________
From: "yetiguy@earthlink.net" <yetiguy@earthlink.net>
To: Byron Tatum <bjtatum1@att.net>; towertalk@contesting.com
Sent: Sat, May 29, 2010 11:09:43 PM
Subject: Re: [TowerTalk] A couple of Inquiries
Byron,
You can probably get the balun spec from Cal-Av Labs directly. They have moved
to Tucson, AZ. Send your enquiry to info@calav.com.
73, Dennis K6IFB
-----Original Message-----
>From: Byron Tatum <bjtatum1@att.net>
>Sent: May 29, 2010 9:40 PM
>To: towertalk@contesting.com
>Subject: [TowerTalk] A couple of Inquiries
>
>Hello-
> If I could impose for some information:
> 1. I bought a NOS HyGain TH3 MK4 and started assembling it today. The
>very first joint I tried to clamp was an element tip, where the small 1/2"
>tubing slips inside the slotted end of a trap. I could not tighten the hose
>clamp enough (with a nut driver) to get a sufficient squeeze to hold the 1/2"
>element tip. What is the best solution to this? I do not want to do anything I
>would regret later, but my thoughts were to saw another slot in the tubing,
>opposite the single slot that is present now. I wonder if the larger element
>pieces are the same way - they are thicker and look tough to squeeze.
> 2. I found a balun by Cal-Av Labs (suspect is older one) model TL-3.
>It appears as a torroidal balun, is in a square metal case with 2 mounting
>holes. Does anyone have any specs on this balun?
>
> Thank you,
>
> Byron WA5THJ
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|