[Top] [All Lists]

[TowerTalk] Ham IV rotor reassembly

Subject: [TowerTalk] Ham IV rotor reassembly
From: Barry Gross <>
Date: Fri, 29 Oct 2010 15:56:52 -0700 (PDT)
List-post: <">>
I seem to be stuck at the last step of a Ham IV reassembly and would appreciate 
any helpful advice.  I've lowered the main assembly into the upside down upper 
housing and made sure the potentiometer arm got seated along with the 3 housing 
guides.  I've got both bearing retainers with proper side down, etc.  I've 
lowered the brake housing into place and lined up the 4 bolt holes after 
releasing the brake but there's just a slightly too big gap between the 
housings for the bolts to reach across and get threaded.  

Is it normal to have to wrestle across a gap between the upper/lower housings?  
Any tips appreciated.

Thanks & 73,
Barry N1EU


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>