Gil,
Thank you for the reply. I took a look at the end cap yesterday. This
looks like one of those things that would be a PITA to get lined back
up. Have you done this? If so, how difficult was it really?
-Kurt
KR2C
On 10/31/2010 5:49 PM, Richard M. Gillingham wrote:
> I'd lower the mast to horizontal and remove the bottom cap. You should be
> able to remove the top mast section from there.
> You'll need a wrench to remove the screws securing the cap and a block of
> wood and a hammer to tap the edges of the cap to remove it. Mark the cap
> and mast so you can replace it accurately
> Replacing the cap you'll need to accurately align the screw holes and then
> don't over tighten them..
>
> Good luck
> Gil, W1RG
> ----- Original Message -----
> From: "Kurt Cathcart, KR2C"<Kurt@KuhlRoad.net>
> To:<towertalk@contesting.com>
> Sent: Sunday, October 31, 2010 5:40 PM
> Subject: [TowerTalk] US Tower MA40 mast oops
>
>
>> I've been working on putting up a US Tower MA$ rotatable mast. In my
>> haste to put the mast vertical for the first time, the 2" innermost
>> section wasn't tightened down and slid in to the base section. Would
>> anybody have any ideas on how to get it back out?
>>
>> -Kurt
>> KR2C
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|