I think that I saw a short article in QST in the past two years about how to
make coax standoffs for a tower using Schedule 40 "Ts". I think that a "T"
was fastened at the top of each section of the tower. Then the coax &
rotator cable was put thru the standoff. When the tower is raised or
lowered, the coax slides thru the standoff.
Any idea which issue of QST & page it is in? Up until now I have been
taping the coax to the tower legs about every five feet when it is raised.
Then I have to cut the tape off when I lower it.
73, Duane, AA6EE
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|