| To: | towertalk@contesting.com |
|---|---|
| Subject: | [TowerTalk] Copper Pipe Ground Rods - Driving them in - How ? |
| From: | Dan Bookwalter <n8dcj@yahoo.com> |
| Reply-to: | Dan Bookwalter <N8DCJ@YAHOO.COM> |
| Date: | Wed, 25 May 2011 05:28:31 -0700 (PDT) |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
Ok , I have most of my ground system planned out , my plan is to use copper pipe (type "L") and silver solder flashing to them from the tower etc... my issue is how in the world do you guys drive copper pipe into the ground , I have access to a 1/2" hammer drill , but , the pipe is too large for that , I am going to check into a ground rod bit for it , but , I am still not so sure if that will work. Suggestions ?? Dan N8DCJ _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Need for a LM470 sheave(pulley), K0DAN |
|---|---|
| Next by Date: | Re: [TowerTalk] Copper Pipe Ground Rods - Driving them in - How ?, Tommy Alderman |
| Previous by Thread: | [TowerTalk] Need for a LM470 sheave(pulley), K6QD |
| Next by Thread: | Re: [TowerTalk] Copper Pipe Ground Rods - Driving them in - How ?, Tommy Alderman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |