On 8/29/2011 8:11 AM, Mike wrote:
> Put the U shaped end around the tower leg, or over the pin of an attachment
> fixture,
> or through the eye of the ground anchor or turnbuckle and wind the two legs
> in a
> spiral pattern onto the end of the guy wire.
>
> Very secure, very easy to install, nothing to rust or loosen over the years.
> You can
> also put one on the guy several feet from the ground end and use a com-along
> between
> it and the anchor to tension the guy so you don't take up all your turnbuckle.
>
> Take a look here
> http://www.preformed.com/preformed/files/ps/PLP_CommCatSec20-2010t.pdf
>
> I'd suggest that you find a ham or two in your area to Elmer your
> installation.
Amen! The first few can be really awkward, but after that they are
fairly easy to install and are not a weak point like cable clamps. When
used with Phillystran the cable should be under tension when the "Big
Grips" are installed.
73
Roger (K8RI)
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|