The instructions for the sdx models say that different transformers are
installed to change the input voltage. I don't know about the dxa but
suspect it is the same. You can run these on green heron or any other
controller that puts out 8-24vdc for the motor and uses a 500ohm pot for
indication.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://wiki.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://k1ttt.net
> -----Original Message-----
> From: slonim aron [mailto:as1935@012.net.il]
> Sent: Friday, November 11, 2011 10:21
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ac connection.
>
>
> Hi,
> Have the Yaesu G-2700SDX and the G-2800DXA
> motors.Both are marked 110ac, wonder if there is any tap
> on the transformer inside the control unit which will allow
> 240vac (main in Israel) operation?
> Thanks .
> Aron 4x1fq.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|