On 1/4/2012 12:48 PM, Rick Karlquist wrote:
> Tim Duffy K3LR wrote:
>> A few months ago I asked a question on this reflector about tools that
>> would
>> help tighten PL-259 connectors on remote coax switches, four square boxes,
>> stacking boxes, etc. Anywhere there is a tightly grouped cluster of SO-239
> My preferred solution is to install permanent short (~1 foot) jumpers on
> hard to get to connectors on the box. These can be installed in
> consecutive order on the bench and tightened very securely under
> the best conditions. Once the box is pigtailed, then any field
> tightening is being done on in-line connections and is easily done
> with visegrips.
Problem is that with wide temperature variations connectors sometimes
work loose although the pigtails sound like a good idea and would
probably cover well over 90% of problems.
73
Roger (K8RI)
>
> The spark plug pliers are for pulling spark plugs, not turning
> them. You still need a spark plug wrench for that. I can't see
> how spark plug pliers would be able to tighten a nut.
>
> Rick N6RK
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|