I leave the ends of the coax open and measure across the choke with the short
test leads attached to the shield at either end. Just like you would measure
any inductor. The AIM will then plot Impedance, Reactance and Resistance as a
function of frequency.
73 Craig AC0DS
So you short shield and center together on each end, and then measure
across the whole assembly with some jumpers from Coax on AIM to the UUT?
Or just the center, or the shield?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|