Towertalk
[Top] [All Lists]

Re: [TowerTalk] Sprockets with 2" bore needed

To: K8RI <K8RI-on-TowerTalk@tm.net>
Subject: Re: [TowerTalk] Sprockets with 2" bore needed
From: Grant Saviers <grants2@pacbell.net>
Date: Fri, 27 Apr 2012 20:29:00 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Browning is another choice for sprockets.

Why not use a timing (synchronous) belt instead?  It won't rust and can 
be sized for any load you might need.

http://www.emerson-ept.com/eptroot/public/prod/dynamic_frame.asp?strMain=http%3A//www.emerson-ept.com/eptroot/public/bnames/browning/Browning.htm

Applied Industrial Technologies also stocks sprockets, chain, belts, etc.

http://web.applied.com/base.cfm?page_id=3397

Grant KZ1W

On 4/27/2012 2:00 PM, K8RI wrote:
> On 4/27/2012 4:34 PM, Jim Hoge wrote:
>> Check McMaster- Carr. They list them but with a higher price tag. The 
>> manufacturer you want to search is Martin Sprocket and Gear. Any supplier of 
>> power transmission equipment ought to carry them. If you can tolerate a 
>> larger outside dimension then you can away from searching for only finished 
>> bore sprockets and go for bushing bore sprockets as well.
> I had e-mailed them earlier.  I just received a reply back stating they
> could not make a recommendation for my application which was:
> 2" ID/Bore, finished or machinable, OD of roughly 4" and a linear force
> on the chain of 500# which includes a safety factor.
> I know I've seen systems that ran far more force than this.
>
> Torque on the 2" shaft is roughly 1000 inch # at maximum wind gust. With
> an OD of 4" this is reduced to 500# which would translate to 500 linear
> #  on the chain.
> OTOH the small rotator can go to about 1500 in # so that would translate
> to  750 # of linear force on the chain.
>
> I have looked at the bushing bore sprockets, but not specked any out.
>
> 73
>
> Roger (K8RI)
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>